Controller: Vestax VCM-600

3.52K viewsCSS Controller Templates
0
0 Comments

Further to a user request, here is an “in progress” Controller file of the Vestax VCM-600 for import direct into Control Surface Studio.

Status “in progress”
The UI of the Controller is built but now needs all of the correct MIDI Message values putting in to each control.
If someone has this controller (or midi message list) and could update the file then upload it to this thread for everyone, that would be amazing!

Thanks

John

admin Changed status to publish
Attached Files:

14 Answers

0
deadunit 0 Comments

here’s an update to the VCM-600 mapping file from Blair if anyone is interested.

awesome work with the layout and all the CC and note values and all the hard stuff
it was confusing me that lots of knobs and buttons had the same name (multiple knob 8 etc)

rearranging was a challenge as I had to work backwards from the end, freeing up higher numbers to be available for lower numbers before I could set them correctly.

after a bit of back and forth, settled on:
channel 1 knobs and buttons are 10-19
channel 2 knobs and buttons are 20-29 etc
for all 6 channels

(there’s 8 knobs per channel but 10 buttons, hence starting from 0, so the EQ buttons could align with their knob counterparts but have them all still fit inside 10, so I could remember where I was up to)

the macro knobs are 81-88
the return pans, master cue and master pan and related buttons are 91+

other system buttons and knobs are from 100 onwards

sliders are 1-10

hope this is useful for someone.

admin Changed status to publish
Attached Files:
You are viewing 1 out of 14 answers, click here to view all answers.

Categories