On every project load (new or old) in Ableton, all buttons and knobs don’t start to work immediately

I managed to achieve almost everything I need with remotify custom scripts, but I can’t figure out how to solve one problem.
Scripts I made with remotify works ok in Ableton, but there is problem every time when I load (any) Ableton project again.
Then not a single button work immediately, rather it must be pressed 3 times to start trigger the mapped button in Ableton / VST instrument. Then, after presing all buttons on hardware controler couple of times, everithing work fine and Ableton / VST follow every press on hardware buttons. Then also start to work midi feedback for buttons, and every time I pres some software maped button, hardware button folow with is light. The similar problem is also with rotary knobs with circle led light around for knob level positions. When I load saved project, led postions on the biginig dont take the postions where it has been, when project is saved. But when move a little every hardware rotary knob (or every softvare knobs that are mapped in Ableton / vst), then everithihg start to work ok. For example, when I change sound presets in VST, and VST software knobs chage postions, hardvare knob led indikators folow every preset changeing, but only until I load Ableton project again. And then problem starts again.
I paln to make custom script for a lot controlers that will work in paralel together, and if it were necessary to move all the knobs and press the buttons every time the Ableton project was loaded until the connection betven hardware buttons and knobs established, that would be a lot of knobs moveing and button press for every Ableton projec load.
Please, is it possible to solve this problem or what am I doing wrong in script?
I upload just simpe script and controler with only 2 knobs and two buttons that trigger selected track 1st loaded VST 4 cotrols, 2 software knobs, and 2 soft buttons of vst instrument.