Switch On Sending Value of 100, Rather than 127

I set up my encoder switches in Control Surface Studio like any other button. Then used the Device function in each Track to map the perimeter I want them to control (Utility > Mono)..

The issue I’m running into is that clicking the encoder is only setting the value to 100, instead of 127.

I’ve check all of the settingsI can think of and the range is correctly set to 0-127, snapping is on, and range is 0% to 100%. I’ve tried changing message type on. my controller from Note to CC, but that did not make a difference. I’ve tried changing settings in CSS from Absolute to On/Off. I tried changing Momentary to Toggle. None of these seem to resolve the issue. I was a able to do a workaround to test one parameter where I mapped the on and off function to a macro knob, which accepts anything above 64 as “on,” but I can’t do this workaround for everything I need to map.

Any other ideas on what the issue may be or a setting I can make to resolve it?

Thank you