Switch On Sending Value of 100, Rather than 127

1.68K viewsGeneral
0
0 Comments

I set up my encoder switches in Control Surface Studio like any other button. Then used the Device function in each Track to map the perimeter I want them to control (Utility > Mono)..

The issue I’m running into is that clicking the encoder is only setting the value to 100, instead of 127.

I’ve check all of the settingsI can think of and the range is correctly set to 0-127, snapping is on, and range is 0% to 100%. I’ve tried changing message type on. my controller from Note to CC, but that did not make a difference. I’ve tried changing settings in CSS from Absolute to On/Off. I tried changing Momentary to Toggle. None of these seem to resolve the issue. I was a able to do a workaround to test one parameter where I mapped the on and off function to a macro knob, which accepts anything above 64 as “on,” but I can’t do this workaround for everything I need to map.

Any other ideas on what the issue may be or a setting I can make to resolve it?

Thank you

admin Changed status to publish
Attached Files:

9 Answers

0
Seth 0 Comments

Hi Wim,

Thanks for your reply, I believe your solution of reactions will solve my problem, however it is less elegant as requires 16X action blocks instead of just a single Parameter Bank which I believe should work.

I’ll describe my problem in more detail as to me it seems like a bug but I may be mistaken:

I have a controller with 16X momentary buttons and 16X RGB LEDs. I want to control a single Live 11 device’s 16X macros. I.e. turn on/off each macro with each button and feedback the status to the LEDs.

By simply creating a parameter bank with 16 parameters in CCS and mapping it to the device everything works great BUT the macros are only toggled from 0 to 100 as described at the start of this thread. If the “Maximum” value is increased to 127 then it toggles the macros fully on however it breaks the LED feedback. If this makes sense to you and is intended then that’s fine I can go the reactions route, I just can’t see why the LED feedback shouldn’t work.

Let me know if I can provide more detail / upload my script.

Thanks,

Seth

admin Changed status to publish
Attached Files:
You are viewing 1 out of 9 answers, click here to view all answers.

Categories